GEO5 软件

在线帮助

Tree
Settings
Program:
Language:

Coordinate Systems

Global coordinate system

-

is right-handed

-

the positive X axis is directed from the left to the right

-

the positive Z axis is directed from the bottom to the top

-

the positive Y axis drills in to the XZ plane

-

the rotation about the Y axis is positive when measured clockwise

-

The GCS is used for coordinates

-

in general, the positive surcharge is assumed to act in the opposite direction to the positive axis and the positive rotation follows the positive sense of the global rotation

-

particular definitions of the positive direction must be carefully examined for all cases

Surcharge

-

is always assumed to act along the horizontal line (or at a point)

-

the origin (point) and the length are the required input data

-

the positive surcharge at zero angle is assumed to act in the opposite direction to the positive direction of the Z axis

-

the zero angle corresponds to vertical surcharge

-

the angle increases clockwise

-

the angle ranges from <-180º to 180º>

Anchors

-

an anchor can also be specified by the origin and an angle

-

the zero angle corresponds to the direction of the X axis

-

the angle increases clockwise

-

the angle ranges from <-180º to 180º>

Prescribed displacements and rotation of supports

-

prescribed displacements are positive in the directions of the X, Z axes and about the Y axis

-

displacements are positive when developed in the opposite direction to the positive directions of the coordinate axes

-

the positive rotation is measured clockwise

Load of beams

-

the local coordinate system is right-handed

-

the positive XL axis of the beam is assumed in direction from the starting to the end point

-

the positive ZL axis is perpendicular and rotated counterclockwise by 90º from the beam axis

-

load can be applied three directions:

- global Z

- global X

- local normal (Z)

-

the positive load in the global direction acts in the opposite direction to the positive direction of the corresponding axis

-

the positive load in the normal direction acts in the opposite direction to the positive direction of the local ZL axis

-

the positive load angle α is measured clockwise

-

the moment is positive when acting clockwise

-

definition of load along the XL axis

- coordinates, coordinates of the origin

- load span

-

types of load (always in above mentioned directions)

- concentrated force

- concentrated moment

- distributed uniform over the entire beam

- distributed trapezoidal over the entire beam

- distributed uniform over a segment of the beam

- distributed trapezoidal over a segment of the beam

Stresses and strains

-

positive normal stress Sigma corresponds to compression, negative to tension

-

positive normal strain Epsilon corresponds to compression, negative to tension

Internal forces along beams

-

positive normal force corresponds to tension, negative to compression

-

positive normal strain Epsilon corresponds to compression, negative to tension

Try GEO5 software for free.